Question 1

Longer Picatinny rail for MAKuick mount

Accepted Answer

On the link below you can find the MAK Picatinny Adapter for MAKuick Base

https://www.optics-trade.eu/en/mak-picatinny-adapter-for-makuick-base.html

You can choose between the following lengths: 120mm, 160mm 240mm and 500mm

Question 2

Rusan pivot mount for a second scope

Accepted Answer

In order to be able to suggest a suitable Rusan pivot mount without bases, we need accurate information about your rifle.

Be so kind and tell us which rifle you have.

Question 3

Picatinny rail for Sig Sauer SSG 3000

Accepted Answer

On the links below you can find the rails suitable for your rifle:

https://www.optics-trade.eu/en/contessa-picatinny-rail-for-sig-sauer-ssg-3000-0-moa.html

https://www.optics-trade.eu/en/eaw-steel-picatinny-rail-sauer-ssg-3000.html

Question 4

Picatinny rail with 20MOA for Tikka T3

Accepted Answer

On the link below you can find suitable picatinny rail for the Tikka T3x Tac A1

https://www.optics-trade.eu/en/mounts/shopby/ring_diameter-lm_rail/suitable_for_rails-weaver_rail.html

Question 5

Aimpoint Mounts

Accepted Answer

The mounts which you are interested in have been discontinued.

Question 6

Picatinny rail for Steyr Mannlichier Mod 69

Accepted Answer

You need to slide the rail on the prism.

Picatinny rail is supplied with the 4 screws. The screws are for tightening. You just need to tighten the screws and this will hold the rail on the rifle.

Question 7

Scope mount for Blaser BBF (700/88)

Accepted Answer

On the link below you can find mounts suitable for Blaser BBF

https://www.optics-trade.eu/en/mounts/shopby/ring_diameter-30_mm/suitable_for_blaser-blaser_bbf_95_97.html

Question 8

Picatinny rail – to glue or not to glue?

Accepted Answer

Our mounting advice:

Remove all the stains (grease, oil etc.) from the rifle’s receiver with a cleaning fluid (acetone). Once the surface is clean and dry, check whether the screws match the rail and the holes on the receiver. Make sure that the Picatinny rail is compatible with the rifle by inspecting the mounting holes on both. Before mounting the rail permanently, apply a minimal amount of thread-locking fluid 278 or 648 on screws and contact surfaces. Be careful not to get the fluid in or near the mounting holes. Carefully clean the remaining excess fluid around the rail with a cleaning fluid. Using a torque driver, screw the screws appropriately (up to 2.2 Nm) – do not overtighten.

Question 9

Picatinny rail for CZ550

Accepted Answer

On the link below you can find picatinny rails for CZ 550

https://www.optics-trade.eu/en/mounts/picatinny-rails/shopby/suitable_for_cz-cz_550.html

Question 10

Swarovski SR mount for Tikka T3

Accepted Answer

On the link below you can find all mounts suitable for your rifle and scope with the SR rail:

https://www.optics-trade.eu/en/mounts/shopby/ring_diameter-swarovski_sr_rail/suitable_for_tikka-tikka_t3.html

Mounts – Page 29